Cybex Treadmills Error. Коды ошибок беговых дорожек
16.01.2017
ERROR DESCRIPTION PROBABLE CAUSE
bAd0 Bad Checksum Turn the treadmill to the off (O) position and back on, Replace
display board
bAd2 Internal RAM error Turn the treadmill to the off (O) position and back on, Replace
display board
bAd3 Watchdog timeout T Turn the treadmill to the off (O) position and back on, Replace
display board
Err1 Belt didn’t start (or no speed sense) Perform speed calibration, check speed sensor, check motor
brushes, drive motor, display cable then lower board
Err2 Under speed (2mph for 2 seconds Perform speed calibration procedure, check speed sensor,
without correction in process) check belt and deck then drive motor
Err3 Speed sense lost Check speed sensor, lower board, drive motor then display
cable
Err5 No 0 switch sense within timed limits. Check elevation motor calibration, then lower board
This is declared when the timed
elevation reaches -2% without tripping
the index
Err6 Over speed (1 mph for 1 second or 2 Check speed sensor
mph for 0.2 seconds without correction)
Err7 EEPROM error (memory lost, loads Replace display board
new defaults, enters Test Mode)
Err9 Brush wear too low. Indicator has been Check and replace motor brushes
activated for over 100 miles
ErrE 0% always on (or switch disconnected Check elevation motor calibration
or wired backwards). This means that
timed elevation has gone up 2% and
the index is still sensed